![]() ![]() Weather conditions, harsh cleaning methods, and hig-alkaline, acidic or solvent -based cleaners will affect wear.ĭo not swallow. This period will vary depending on hardness and texture of surface, location of area, surface wear, and the frequency and nature of maintenance products used. UltraCare Penetrating Stone, Tile & Grout Selaer is expected to protect against common stains for up to 5 years. If the water soaks in, an additional coat of UltraCare Penetrating Stone, Tile & Grout Sealer will be necessary to keep the sealer at its maximum level of performance. To test, apply a few drops of water on the surface. Sealed surfaces should be tested periodically. For additional maintenance instructions, please refer to the UltraCare Maintenance Guide. Clean countertops using UltraCare Everyday Stone & Grout Cleaner & Resealer. Clean floors using UltraCare Concentrated Tile & Grout Cleaner. Sweep, dust, mop or vacuum often to remove sand grit and debris. Store between temperatures of 40 degree F to 90 degree F (4 degree C to 32 degree C). Drying time may be affected by environmental conditions.Ĭlose container tightly after each use. For best results and stain protection, ensure that the area is kept dry for 12 hours and free from staining materials for 3 days. After the final coat is applied, do not use or walk on surface for at least 3 hours. This coat should be applied 1 hour after the initial application. Very porous surfaces may require a second coat for maximum stain resistance. If a light residue appears, simply remove using a towel dampened with warm water.Ĩ. Remove any non-absorbed sealer from the tile and grout by buffing until dry with a clean towel. Allow 5 to 10 minutes for sealer to soak into surface.ħ. (1,39 m2), liberally apply an even coat using a paint pad, sponge, brush or roller.Ħ. Working in a small manageable area of about 15 sq. ![]() Protect baseboards and tape off surfaces not intended to be sealed.ĥ. Begin with a clean, dry surface that is free of waxes and coatings.Ĥ. * Coverage will vary depending on joint size, tile size, porosity, texture, surface absorption and the amount of dirt to be cleaned.ģ. Up to 1 year when stored in the original sealed container. Avoid skin and eye contact by wearing chemical-resistant gloves and saftey glasses.Refer to safety data sheet for more information.Īlways test first in several inconspicuous areas and wait 12 hours to confirm desired results. Note: Choose all appropriate safety equipment before use. Ensure that the area is well-ventilated during application and until the surface is dry. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |